KRISSTALK
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Factory pinned stock to folding stock

2 posters

Go down

Factory pinned stock to folding stock Empty Factory pinned stock to folding stock

Post by Qbanhitman67 Mon Nov 10, 2014 9:11 pm

Hello I am new to the Kriss Vector , I purchased the state compliant model with the pinned stock and would like to replace it with the folding stock one. It is legal in my state and I am wondering how to do this,, is it an easy remove and replace or should I send it to the factory to have them replace it. Thank you

Qbanhitman67

Posts : 2
Join date : 2014-11-06

Back to top Go down

Factory pinned stock to folding stock Empty Re: Factory pinned stock to folding stock

Post by bolus Wed Nov 12, 2014 1:43 pm

I did the same thing. There is some information in my other threads. The process to change to the M4 adapter is similar to installing a folding stock

http://www.krisstalk.com/t1153-converted-a-fixed-stock-to-a-folding-stock-using-kwa-airsoft-parts

http://www.krisstalk.com/t1151-m4-stock-adapter-at-buds

Here is another thread on removing the fixed stock portion

http://www.krisstalk.com/t1143-sig-sauer-sb15-arm-brace-on-the-kriss-vector-sdp-pistol-updated-9-24-14-mod-completed

bolus

Posts : 43
Join date : 2014-05-12

Back to top Go down

Factory pinned stock to folding stock Empty Re: Factory pinned stock to folding stock

Post by bolus Thu Nov 13, 2014 5:38 pm

another place to get the latch parts
http://www.budsgunshop.com/catalog/product_info.php/products_id/711010548/Stock+Latch+Button+Kit

bolus

Posts : 43
Join date : 2014-05-12

Back to top Go down

Factory pinned stock to folding stock Empty Re: Factory pinned stock to folding stock

Post by Qbanhitman67 Thu Nov 13, 2014 9:10 pm

Thank you Guys!!!!! Now what drill bit size should i use????

Qbanhitman67

Posts : 2
Join date : 2014-11-06

Back to top Go down

Factory pinned stock to folding stock Empty Re: Factory pinned stock to folding stock

Post by bolus Thu Nov 13, 2014 9:18 pm

I used a drill bit that was about about half the size of the width of the head of the pin. the pin can spin in place. so I had to go very slowly and it took a while using the drill press. Just tiny advances at a time and then back off if the pin starts spinning. .

The pin has threads in it on both ends like my other post mentions. So if you go very slowly and carefully, you can run a tap through it and salvage it. But it would probably be easier to just replace the pin once you get it out.

bolus

Posts : 43
Join date : 2014-05-12

Back to top Go down

Factory pinned stock to folding stock Empty Re: Factory pinned stock to folding stock

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum