KRISSTALK
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Geared Head Works TailHook and YetiWurks adapter

2 posters

Go down

Geared Head Works TailHook and YetiWurks adapter  Empty Geared Head Works TailHook and YetiWurks adapter

Post by jsha22lr Mon Jul 24, 2017 10:00 am

After patiently waiting and trying to rig a side folding brace for the Kriss Vector, I finally have the configuration that I believe should have been the way it left from that factory. The adapter is made of 6061 aluminum, and hard coat anodized. To install the adapter, all you have to do is unscrew the set screws holding the factory butt pad on, slide the adapter in, and tighten down the set screws. Then slide on the tail hook. I have it set at furthest in position, which is actually equivalent to the factory OEM stock. Same thickness and width, so it folds and locks up nicely. The tail hook is slightly longer than the OEM pad. Now with this brace set up it will fit nicely into a Vertx transit case with room spare for extra mags. Geared Head Works TailHook and YetiWurks adapter  Img_0211
Geared Head Works TailHook and YetiWurks adapter  Img_0212
Geared Head Works TailHook and YetiWurks adapter  Img_0210

jsha22lr

Posts : 47
Join date : 2016-11-24

Back to top Go down

Geared Head Works TailHook and YetiWurks adapter  Empty Re: Geared Head Works TailHook and YetiWurks adapter

Post by sniiped Wed Dec 13, 2017 3:18 pm

Looking good. I have the same setup. I just have to pick up the new vector when I go home for christmas.

sniiped

Posts : 23
Join date : 2013-08-16

Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum